Deform the foot arch height using the skeleton axis.
※ It does not proceed in the foot model deformed by foot posture correction.
※ It has to be operated with the original scan foot model.
Mesh Model
Select a target foot mesh model that has the skeleton.
|
|
Type
Display whether the target mesh model is left or right foot.
It is automatically selected by the skeleton information.
|
|
Foot Arch Height Level
Adjust the level of the foot arch height.
HL0 is the recommended standard level, it is measured as the (-) level for low arches and the (+) level for high arches.
The arch height level cannot be lowered at the current measured level.
|
|
LAA Calculation
It shows the LAA calculation value according to the adjustment of the mid foot arch height level.
|
|
Arch Height Index
It shows the arch height index value.
The arch height of the 3D scanned foot is shown using its own calculation algorithm.
An R-AHI of 3.0 to 3.6 is considered normal, an R-AHI of less than 3.0 is assumed to be a low arch and an R-AHI of 3.7 or more is assumed to be a high arch.
|
|
Run
Apply the foot arch height level adjusted to the target mesh model.
The foot arch correction mesh model is generated as a copy model with suffix _R0, R01, etc..
|
|
Close
Close the panel window.
|
|