To properly display this page you need a browser with JavaScript support.
The foot model, defined as a standard library containing skeleton information, is loaded, and the design draw function is used to create a design curve and register the template design.
Close Curve Mode Keep the closed curve connecting both endpoints
In the Close curve mode, the two endpoints operate like one point.
Line Type Define the type of line connecting the points.
In Edit mode, select a point and change the line type.
• Spline : Curves between points.
• Polyline : Straight line between points.
Start/Finish Curve To create a curve, click the Start curve button and finish one curve with the Finish curve button.
Create smooth curves with minimal points.
Do not create curves that deviate from the skeleton base point of the toe area toward the toe.
To create a curve, click the Start curve button and finish one curve with the Finish curve button.
Create smooth curves with minimal points.
Undo Cancel the last specified point
Edit/Finish Start/Finish edit of Curve points.
Select the curve to edit and activate the Edit mode.
Finish when you finish editing Curve points.
Move Point : Modify the curve by clicking on the selected point and moving it to the desired location
Add Point : Add a point in the curve.
Delete Point : Delete the selected point in the curve
Delete Point function has to click the button first and select points to delete.
Since there is no cancellation function, if you delete it incorrectly, you must add a point again with the Add Point function.
Extend Curve
Extend the curve by adding a pointer from the end point if it is not a closed curve
In the case of closed curves, remove the closed endpoint and extend the curve by adding a pointer at the endpoint.
Select the target curve, click the Extend curve button, first click the endpoint and expand the curve by add points.
Click the Finish button to complete the extend curve.
Offset Curve Select the target curve, click the Offset curve button and specify the offset position to copy the curve.
Delete Curve Remove the only selected curve.
Clear Curve Delete all curves on working on.
Save Curve
The list of curves is displayed in the project tree window.
Curves that have been created but not saved are marked with an * in front of the curve list in the tree window.
The saved curve information is saved as an XML file in the project curve folder.
Load Curve
Add curves by loading an XML file of curves information stored in the curves folder.
The model must be in the same position to use the loaded curves
Select Template Model
Select a template model from library.
User can execute additional jobs with the right mouse click.
• Rename : Change name of selected template model.
• Delete : Delete selected template model.
• Upload : Change representative image of template.
Default system templates can not be edited.
Save Template Design Save the current curve design as a new user-defined template with its name.
Load Loads selected template design curve.
• Tip. User can create a new template by editing the loaded template with ‘Draw’ and ‘Save’.
